[iNVisionPROTOTYPES]

With a hand-crafted vehicle every single piece ... even the things no one sees ...is created by hand.

Here's a small insight into the rear hatch - A few sketches are created, followed by pressed paper templates and finally the metal forming itself...

After pieces are formed, overlapped and screwed together the section is installed for a trial fit.


Overlapped areas are trimmed away, sections butted together and welded.


A little hammer dollie work is necessary to clean up the welded areas.


...and finally finishing it off.


When you get a chance visit and follow us on our Facebook site.

ClickiNVision Prototypes' R2 Build on Facebook for more !

Cheers!