View Single Post
Old 05-08-2012, 01:52 PM   #8
rkvons
AF Enthusiast
 
rkvons's Avatar
 
Join Date: Aug 2007
Location: Bolingbrook, Illinois
Posts: 820
Thanks: 23
Thanked 43 Times in 42 Posts
Re: Car Starts Weakly, After Time Doesn't Start at All

Quote:
Originally Posted by Brandybuck View Post
Update: I tried Oscar's suggestion of turning the key from off to run several times before cranking. Following are the results:

Initial Conditions: Had not started car for about 32 hours. (I didn't try to start it until after turning the key from off to run five times for the first time.)

turned key from off to run five times, then turned to start. Car started immediately without hesitation, and seemed to have fair power.

turned off car. turned key from off to run five times, then turned to start. Car cranked/turned over, but didn't even come close to starting.

repeated this procedure twice, with identical results.

So it was only after the first cycle of turning the key from off to run that the car started; after that, it was ineffective.

(It could very well be, by the way, that the car would have started the first time, after only turning the key once, but I didn't try this.)

Can anyone interpret these results for me?

(I wanted to clarify that my engine does not run rough or idle inconsistently; it is just that the idle sounds very low-powered compared to the other Grand Prix. It also does one of three things when I try to start it: crank but not start at all, crank but start only after a couple of seconds, or crank and start immediately, albeit with low power. I am getting the impression that it only starts immediately when I have been running the car for a while soon before starting it again.)

Thanks!
Put a fuel pressure gauge on it and see if it is within specs. When you turn the key to on, the pressure should "bang" up to 50psi, or so (others can be more precise). After you start it, it should be at a lower level and vary by how much you press on the accelerator. You may have a fuel pump resistor that is going out. Your pump has the full 12V when you first turn the key to on, and after the engine starts, it is reduced through a resistor.
rkvons is offline   Reply With Quote
The Following User Says Thank You to rkvons For This Useful Post:
Brandybuck (05-11-2012)