Quote:
Originally Posted by mixin
I took out my dremel tool with a fine wire brush wheel on it and cleaned up the terminals on the old cap and rotor. I swapped the new set for the old set and now it runs fine.
In looking at the plug wires on the even side, I could not read the numbers I wrote on anymore - so I guess it's possible I switched them when I put the new cap on. Wish I had time to put the new cap back on again to prove it - but I ran out of time and the truck is running good.
Sorry to leave you all in suspense with what the problem is - I dunno either. Just glad the truck is running good again!
Mike
|
The white stuff is normal build up.
No problem there..
If cap does go bad always replace with a AC-delco.
They are numbered for plug wires to.
If RUNNING GOOD WITH OLD CAP LEAVE IT ON THERE.