[Eero15]

Then underside mold got ready so it was time for some test-casting. First cast was total failure. Epoxy concentration was wrong so the details were very fragile and broke very easily. So i rechecked the concentration and went for another go. I was quite pleased with the result. I got to know the amount of epoxy needed for casting. Now i need to make some arrangements in techniques and I am ready to continue casting.
Molds:


Second test:



Then I Finished the mold of the body. I used wooden blocks to make the ejection of the mold easier and to save material.

Wooden block with supports.

Almost finished underside of mold.

Pouring upper side of mold.



In the end I cover it with glass and put powerdrill on top for weight.

Finished mold.





To be continued...

Eero