Someone with a plasma cutter,(optional),a gas wrench setup and some 1/4" or 3/16" steel plate can cut and bend up some up brackets to attach to the exhaust manifold studs,( 2 studs reach for each bracket). One for the left front and the other attached to the right rear. Using the proper length spreader bar/ leveler should do it. Like W2O said dont have it squeezing the plastic valve covers or they'll crack. Better yet remove them. Separate it from the trans and torque converter before lifting. Support the trans with a piece of plywood on a floor jack. Hold the torque converter back w/ vise grips to the bell housing so it doesnt fall off the input shaft.