Sorry I couldn't upload that pic-but I'm not very up-to-date with pc procedures.If I had an e-mail address to send it to,I could have fired it off in a minute or two.Guess I would need to have an online photo service or the like. Anyhow, I got the drill piece out by filing a small pointy chisel to a smaller tip, whacking it with the side of a small maul (no room to play under there!)and trying to turn it counterclockwise for a while-and it came loose! I was just about losing hope when I lined it up and the piece wiggled.Thanks,Brian, for trying to help,and if there's an e-mail address to send pix to,let me know! I'm going to go REAL slow,and in tiny increments, drilling the stub out for the largest easy out I can fit in it, so I don't wind up in the same boat with the extractor snapped!-Groovetube