[Gudog]

Well, I bought some carb cleaner and started spraying. Can't beleive you can spray that on a hot engine and not cause a fire! I covered all of the parts that I had installed and no change in idle. I then shot some spray in the hole area shown in the picture and the idle reved up. I guess that is where my leak is eh? However, that is such a tough space to get into....I am not sure where the leak is? The DPFE sensor is back there near the firewall and the tubes connecting to the sensor are right below. I have no idea what the big black three armed metal cover is to the left of the spray area line is but could that be leaking underneath or on the side? I will take it to the mechanic on Monday i guess because if it is any of the items mentioned above...I dont think I can replace them. SHO-Rod....I did replace the rubber tibes that connect to the DPFE sensor and they are on the right pipes so that is not it. It was hard to get those lines on so maybe I bent or cracked the pipes to which the hooked when I was puching down? Any other ideas on whats in that area will be helpful as I can give the mechanic a heads up or maybe try it myself over the weekend.

Thanks for all of your help!

jim