[snorander]

Originally Posted by snorander

so I had the battery out and checke out my actuator. I can't pull the cable at all. The actuator will hods vacuum if remove the vacuum line & put my thumb on it so the actuator is good(I assume). Now for the million dollar question....How can I fige out if the cable is siezed of if the encoder motor is seized?

Thanks,

Steve

My typing is terrible this morning...let me try again...

so I had the battery out and checked out my actuator. I can't pull the cable at all. The actuator will hold vacuum if I remove the vacuum line & put my thumb on it so the actuator is good(I assume). Now for the million dollar question....How can I figure out if the cable is siezed or if the encoder motor is seized?

Steve