Quote:
Originally Posted by grider
if you hav apry bar with a heal or bend near the sharp edge you can hammer the axlw out using the pry bar as a punch from the oposit side you can put the end of rhe pry bar into the groove on the inner cv axle housing and hit it with a large hamer it is posible that you go a rebuild or damaged spline and that is keeping it from going in all the way inspect closly when you get it out good luck
|
If you read my post above yours, it says that I got the axle out. I am in the process of finding a new stub shaft.... unless someone can tell me that the stub shaft seal is not needed (because mine is broke).