[jdl]

You don't have a neighbor or a friend, that can crank it for you? Not sure if you have a schrader valve to check fuel pressure. You may have to tee into the fuel supply line? Just make sure no pressure on fuel line before taking any lines loose.

As far as the codes, you can use a jumper wire between the A & B terminals at the datalink connector, usually located at lower edge of dash. After you install the jumper, turn key just till dash lites come on, no further. The cel lite starts flashing, you count the flashes to get the codes. Your looking for two digit codes.

The picture is for location of A & B terminals.