[tempfixit]

Originally Posted by draasch911

i dont have that set up. here is a pic of what i have. there is the MAF sensor and then nothing until u get to these two parts.

Should asked before, which engine do you have???????????

5.8L And 7.5L Engines





Fig. Typical IAT sensor mounting-5.8L and 7.5L engines

1. Disconnect the negative battery cable.
2. Detach the electrical connector from the IAT sensor.
3. Remove the IAT sensor from the intake manifold.

On California emissions equipped models, the IAT sensor is located in the air cleaner-to-throttle body tube.
To install:

1. Installation is the reverse of removal. Tighten the IAT sensor to 12-17 ft. lbs. (16-24