Quote:
Originally Posted by razorbaq
Ok I noticed the pinion flange was seperated from the housing, After I took it off there was a smashed up bearing ball in there, Just one. Looks like there should be bearings in there, Autozone knew nothing about it and Napa sold me a rear pinion flange seal, They say it takes no bearings, It sure looks like there should be bearings in there, And if not where did the one bearing ball come from, Theres no way for it to get in there from somewhere else.
|
you have 3 bearings. 2 wheel axle bearings left right. then the drive shaft pinion bearing. this is the bearing that broke. now the gears do not engage properly. this will need to be repaired by shimming this to engage correctly when the new pinion bearing is installed.
this is beyond my level of knowledge. never did it !