Quote:
Originally Posted by southeastpm
It is blowing heat right now (needed badly) but it has to be turned around to the cold side for it to work. That is one reason I was not having a fit to get it repaired cause it is still working just not correctly. I have a piece of tape holding it in position cause it is loose and needs the pressure applied. How much of the panel has to be removed to solder the wires (if that is the case)? I will try the nut thing and see what happens. Thanks so much for the assistance.
|
Try this link for how to pull the panel off (page 2)
http://www.tundrasolutions.com/forum...-cool-control/
And this detailed link for info in the whole job
http://www.tundrasolutions.com/forum...-quit-sort-of/
Keep in mind this looks difficult but took me less then 30min and I'm not a master solderer and its been working fine for years now.
Good luck