did some interior work today , im leaving the door and sidepanels stock also rear deck stock..... i removed the rear seats, and "removed" the carpet, i just made the floor looked "stripped" like.......
-here i removed the rear seats and i started plotting on my next move..
-drew a ruff sketch on a piece of paper of what im ruffly looking for..
-i layed the first pieces on...
-added the hump for the fuel pump cover and made the fuel pump cover...
-another shot and angle....
-fuel pump cover its getting wrapped in carbon fiber.....
-did some sanding
-put some lines on the floor with a marker
-then, instead of adding on to the floor to make the "metal" floor, i took my dremel with a cut off wheel and started scribing the floor...
- i took a file to finish up the lines on the floor...... also added the cross bar on the floor plan for the seats to bolt up too, and also added the raised metal to bolt up the rear of the front seats....
-another angle....
-lol had a scrap piece of photoetch and made a vin plate on the dashboard..
-also vin plated the tranny .....see if you can see it.......(it's greenish)
-started working on the PASSWORDJDM carbon fiber airbag delete..... i cut the center of the air bag out leaving a trim.....
-added the carbon fiber, i used solva set to wrap it up....
-here is the back piece of the air bag......0.30 styrene with the carbon fiber decal....
-here it is finished.... will add clear soon....
........................... thats all i did for the interior so far....................................