Quote:
Originally Posted by way2old
The sensor should just pull off. You might need to pry it gently to get it to come loose. You can get by without an alignment tool. Be sure the vehicle is in neutral. There is a little line on the center white section of the sensor. There is a corresponding line on the outside part of the sensor. Line these marks up, in neutral, and tighten screws.
|
Thank You,
way2old! The underlined above in your reply helped me out a lot! I will be giving it a try tomorrow. I am glad to know that photo2
is the shaft.
All of the parts on my van are original and whoever had it before me did
no repairs obviously. Apparently they traded it in (in 2006) just before all this crap I am doing to it needed to be done. Thank goodness I am handy with a wrench and have you all.