[shadow212121]

HELP!

I have a 1996 Mercury Cougar XR7 4.6L

Recently my remote (FCC ID: GOH-M24) hasn't been working so I ordered another one. I dont know how to program my remote, I followed the instructions that you guys have placed but nothing seems to work. I located the button under my dash, i held it down for 15 seconds and the car doesnt go into programing mode. The switch i have located is connected to two brown wires. In order for me to start my car i have to have this button pressed down while i turn the ignition on, then the engine will turn over. I need to use the remote to unlock the car so it disables the starter lockout, Without my remote i always have to press this switch in while i start it (sort of annoying) Is this the right switch i have here or is there another one? I saw another person say that there's a harness i have to jump but i thought those were only for factory installed alarms... I have an alarm system that has been installed by ford AFTER the car was purchased. I'm not the first owner of the car so im not sure how it was hooked up or anything like that.

If you guys know something i don't know, please share your information

Thanks
Kyle