|
Re: turn signal problems
Just posting back in hopes of helping someone later.
Took things apart back there, ground pin had burnt the surrounding plastic on the connector on both the circuit board, and the harness plug, both looked and even smelled burnt.
Ordered a new circuit board off Ebay for 24 dollars, and the wiring harness connector off RockAuto for 37 dollars (ridiculous, but about the cheapest I could find) installed and everything is as it should be.
The circuit board are pretty easy to find, and at the moment are all over Ebay. I did not bother getting a part # for those as they are pretty easy to find.
The harness plug is a bit more obscure and took a little digging to find and verify I had the right part.
The plug is GM part #12101854 and AC Delco part #PT246
I could not find anyone who makes this part besides AC Delco.
__________________
2000 Oldsmobile Intrigue 3.5 DOHC V6
Mods: Fenderwell Intake, High-Flow cat, U-bend delete, 12-inch front rotors, GMPP handling kit, 20% tint, Pioneer front and rear speakers, Eclipse HU, cleared corners
1986 Jeep Cherokee 2.8 V6
|