Quote:
Originally Posted by j cAT
30amp fuse door locks ?????????? I think that is too high..how about 15amps maybe 20 !
as was mentioned remove door panels..using a magnifier with a strong light inspect for wire defects..
lets say you cannot see any , then place some electrical tape over all the wires ...
I found a short to my door windows that was the size of a pin head...very small..
|
I'm surprised I didn't catch too that when I read it the first time. That is a good idea too with the magnifier and I would check especially close to the hinges where there is movement, maybe a grommet came loose and then the sharp metal could have scraped the insulation off of the wire.
To the original poster.
You said it keeps blowing the fuses, did you try using a bigger fuse b/c it was blowing them, make sure you have the right size fuse if not you could wind up with a bigger problem than the one you had to start with, you could burn your wires up by doing that.