[Jmrec100]

I am getting the PO200 error codes which means injectors. I am going to get a noid light and check each injector there. Is there a resistance or another test I can do?

Also, here's the readings I get from my code reader:

Misfire; Ready
Fuel: Ready
CCM: Ready
Cat: Not Ready
HCN: N/A
Evap: Not Ready
2Air: N/A
AC: N/A
O2S: Not Ready
HO2S: Not Ready
EGR: N/A

the O2S and HO2S. How do I check that? Is it related to the injector fails? And the EVAP? Where's that and what is it?

I'm going to pull each injector one by one. If no change then that's the bad one? or ones if more than a single one. I rented the noid lights. After find which one or ones failed, I can check the circuits?