went out this morning and she wouldnt start. new battery, new alternator so those arent problem. pulled out relay for starter and there was a little 'fzzz' and then nothing. bought new relay and new starter(had old 1 tested and it was shot, new 1 tested fine) and replaced both but still no start. all the power comes on, just no crank when i turn key. used tester on wiring that goes into starter and the smaller wire only reads 0.03 when i touch it. plus, when i try the continuity, no beeps at all. any ideas? could the wiring all of a sudden be bad or is it more likely that i fried the ignition switch and if so, how easy is it to replace.