Quote:
Originally Posted by JeenyusVR4
u know what i just checked again and i didnt have a good ground on pin 64 (92 vr4). i checked again and its givin me 1.6 ohms.
|
Quote:
Originally Posted by JeenyusVR4
ok after i tested pin 64 and terminal 2 i am for sure getting 9 ohms, so then i started testing sections of the wire and its only showing 1 to 2 ohms max if not 0. how can this be if i checked every section of the wire but when i test the whole thing it shows 9!?
|
do you mean pin # 84?
did you disconnect the etacs, ecs control unit, and cruise control unit?
you can get erroneous readings if they are plugged in.
also what is the reading you get when you touch the two test leads together?