Quote:
Originally Posted by zbird75
Sorry about the delay,
So I figureed it out. After putting in the new ECM, the security light was on. Leaving the ignition key on in the run postion for 10 min, in 3 cycles, turned off the security light. Must have battery charger on for it to work properly.
After vehicle still would not start, So I was able to find a guy with a tech 2 scan tool, to come by and check. He found that because I put in a new ECM, that the ignition switch was not reading properly and was not allowing the vehicle to start.
To make a very long story short, I replaced the ignition switch and the van is now running great. Thank to everyone whoi helped.
Z
|
Late /delay is better than never.
A lot of posters never post back how it went.
Thanks for posting back the fix and how it went.