Quote:
Originally Posted by turbothirtytwo
I have similar problem as yours when I started to use 2K. what I have learned is to add more thinner to have paint like when u thin normal acrylics or so.almost like milk consystency. and u should spray it very close to subject(maybe around 3cm from kit) and with fully open trigger coz this paint is thick.spray it with slow motions.dont be afraid of runs. and u can strip this clear with isopropilalcohol (IPA) 97% not 91% soak all kit in some contauner that is sealed coz IPA is vapouring quickly and also vapours helps to remove clear. it will lift the clear and u will have to strip it with brush.but nothing difficult. unless u use TS paint under it
|
Wait, You can strip zero 2k with 97% IPA solution?
Awesome! - I have zero 2k on the shelf, waiting to use it, I have IPA too (need to check the %) .... I thought once 2k was on that was it, it would be extremely difficult to remove?