Quote:
Originally Posted by Tobey
Heh, yeah those factory jack points are about as tough as an aluminum can... If I have to use them, I'll put a block of wood (with a slot cut in it, so it fits over the pinch weld) on top of the jack to distribute the weight better.
|
for the rear pinch welds i went with a variation of this using a hockey puck. Mounted the puck to some wood using two drywall screws. Then ran it through the table saw a few times making a 1/3 inch channel about half way down the hockey puck.
Seems to hold up alright for the rear pinch welds so far. (Obviously i'm using it very very briefly until i get the jack stand situated)