Another quick question before I get into this tomorrow. Do the Speed sensors just pull out from the wheel bearing? (to clean them)
I thought they were molded in, but I'm going from memory.
THANKS
Quote:
Originally Posted by j cAT
follow the method I described in the prior posting ..the voltage out of the sensor must be above the 300mv a/c or you get this issue you have ...
if the sensor output is 450 mv ac this is correct and is what you should get ...once again this recall issue was caused by rust so the surface that the sensor sets on must be cleaned to shinny metal then after installing the sensor coat this area well with a undercoating compound..
there is no guessing here also you will get into an accident if this is not corrected...
yes ! the speed sensor in the front hub bearings left/right side under the caliper...
|