Quote:
Originally Posted by driver540
Have a 97 Chevy C1500 with 4.3 manual tranny. Had put new timing chain in and afterwards have codes PO339 and PO341. Have changed every sensor on this darn thing and tuned up twice. Will run for about 15 min. then start runnin rough and die. Will give PO341 everytime even after cleared and sometimes PO339 is given too. Any thoughts?
|
I have seen the crank sensors fail after getting heated ...remove the sensor and measure the resistance cold then heat it up to 212 deg f ..see if it holds the same resistance ..
if the sensor had been installed wrong or a damaged reluctor this would always cause your problem ...same with the connector ,,,but still on something this old could be anything ..