|
For one... the whole floor pan of you car would need modification. There is currently no tunnel for a drive shaft to spin whatever rear axles you're planning on fitting. You would also have to cut and weld your gas tank.
Not sure how you would plan to spin the rear axles anyway. There was an AWD P10 but the whole rear suspension is different from the P11 (hmm.. actually you never stated wether this was for a P11 or P10) If this is for a P11, you'd need to fabricate a lot of pieces in the suspension and drive axle area.
I wont even get into your interior (floor pan mods will effect it)
|