View Single Post
Old 01-08-2010, 11:48 AM   #5
LT1Silverhawk
Prone 2 Ask Alota ?s
Thread starter
 
Join Date: Sep 2008
Location: Lakewood, California
Posts: 112
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Powerglide Transmission: Good for Drag Racing?

Quote:
Originally Posted by MrPbody View Post
PG is a great drag racing transmission within "limits". It's tough and the internals are relatively light for their strength. TONS of aftermarket parts available to make them tough enough for over 1,000 HP.
Wow, up to a 1,000 hp, huh? So I guess the previous owner had a good idea of what he was doing, at least keeping within the reasonable limits and specs of this project.

The reasons I wanted to ask the question that I did was because, not only do I not know anything about Powerglides (or transmissions in general, for the matter), but I was reading an old article from around 1966 in a magazine called "Motorcade" (I think), and it said the Powerglide was an outdated choice for transmission in the Chevelle they were testing. But I guess they meant that from more of a daily driver perspective.




Quote:
Originally Posted by MrPbody View Post
"Rule of thumb" In a car under 3,000 lbs., a 'glide will have a slight advantage over the TH350 or 400. Converter and gearing are critical. For cars over 3,000 lbs., and less than 600 HP, TH350 gets the "nod". When properly built, tough enough. The "deep" 1st gear makes for some good 60' times. For heavier cars with more than 600 HP or more than 500 lbs. of torque, TH400 is (IMO) the best choice.
Not sure what stall converter or the gearing the car is has but I'll check on that as time permits.

On a side note, I am considering a built TH350 or TH400 as a possible swap into my '95 Impala SS with a 383. Transmission went bad Sunday.




Quote:
Originally Posted by MrPbody View Post
For a street car with "taller" gears (in the mid "3s") and less than 500 lbs. of torque, TH350 is called for. IMO, PG is not a good street transmission when more efficient units are available. If you want the "lower" gears like a drag car, TH200-4R ("built") would be my choice, with TH700-R4 another consideration (keep the power lower with the latter). The OD makes it "drivable".

Jim
Thats the question I was originally sturggling with: street, street/strip, or strip? Then I decided since the previous owner did everything to make a pure strip racer, I might as well continue with the same plan (hence the possibility of a 454).

But yes, I agree that a properly built 700R4 will handle the power and give better gas mileage. However, if I install the 700R4, Im'm more like to keep the car longer and I am running low on space.

Thank you Jim! This info helps me alot!
LT1Silverhawk is offline   Reply With Quote