Quote:
Originally Posted by Jarrado
Ok. Engine light actually came on this morning, so I got trouble codes :
35(idle air control system problem, cannot set rpm)
42(electronic spark timing circuit open or grounded during engine run OR direct ignition system fault-bypass circuit open or shorted to ground during engine run OR fuel cutoff relay circuit open or shorted to ground)
and 45(rich exhaust indication-o2 sensor volt. stays high after 1 min. of engine run.
So im open to suggestions...... ??
|
sound to me that you have a computer problem, has anyone replaced it if so they probley did not change the prom from inside the old (ECM) or your prom its self has problems ( use a screwdriver handle) peck on the computer while it is running SEE IF it makes any differance or quits runnig if so you have a bad (COMPUTER !) Danny ! hope this helps