[junk yard doggie]

Pull forward and up, easier said than done. I un hooked the wire harness that goes to the coil pack, ac compressor and crank sensor. I left the coil pack on. The spot where I was hanging up is that back edge of the rack that holds down the cam shaft. It is so tight, I couldn't lift the cover up high enough to clear that spot to slide it out. I pulled all the silver insulation off the heater box and it gave me a little more room in there. I ended up just reefing the cover off. It might go back on easier than it came off. I haven't tried putting it back together yet, was wondering if there is some trick to it. I don't remember having any problems on the older 90's model's. Thanks Steve