[stantony1]

Hi Guys,

So this morning I saw a pool of fluid under my car and determined that it was coming from my washer fluid tank.

I looked through the forums and no one really offers a fix. I read the TSP and looks like the fill tube connected to the tank issue...

So the fluid is leaking from the where the neck is attached to the tank separated by a gasket (rubber?). There is one bolt holding the neck to the frame of the car.

My question is. How is that neck attacked to the tank? Snapped in, or is there a plastic nut on the inside that screws onto the neck base?

I am pretty sure I can just replace the gasket and it should be all set without removing the entire tank. Just wanted to know beforehand if the neck is just snapped on via pressure and gasket, or is it threaded on with threads and some kind of nut?

I also looked through the blueprints and there is no clear illustration of how that neck is attached to the tank.

Any help appreciated... TIA!