|
Re: Cost to replace the O ring on oil pump drive shaft
I replaced the o-ring when I did the LIM - it was right there, so there was no reason not to. However, if you're doing just the o-ring; you may be able to get at it by just removing the throttle body from the upper manifold. Remove the clamp bolt and with a pair of channel-locks pull the drive straight up.
Obviously the part is relatively inexpensive from a GM dealer.
__________________
2000 Venture - repairs to date:
LIM gasket, water pump, wiper park position, front wheel bearings, rear wheel bearings, flickering lights, blower motor resistor, door speaker corroded, rear hatch handle, rear wiper motor, front struts, busted sway bar, LCA bushings, hard shifting tranny (new solenoids!)
|