K ran into a problem. The new master cylinder is not pumping fluid at all. When I put the and old one side by side, the rod in the old one was alot shorter.
I can screw the end that goes to the clutch pedal as far as it will go and it still wont pump. I know this is the right master cylinder but why is the rod so much longer than the old one? It didn't look like the old one was cut. There about a full inch difference. With the old MC it only took like 2 minutes to get the clutch pedal to tighten up. I been pumping on new one for 10 minutes. It wont even bleed.