Quote:
Originally Posted by sjelic
Micha, one question, I was thinking I could bend the spokes, did you try this before, I will drill the hole in the center, put the screw through, screw it to some plastic on the other end, put in hot water and easily tighten the screw, I am not sure would it work but I will try it for sure, after that you only need to sand outer part of the rim to get those spokes on the edge.
|
Thatīs an interesting idea, Sasa. Just one thing: if the wheel with the screw is in hot water, the outer ring itself gets softer, too. If you tighten the srew, the outer ring might be deformed?