Ok... so i've spent a couple of hours how hooking the wires up. Nothing happens when I powered up the module. All it ever did was a sound when I put in the fuses on the two hot wires from the ignition harness and that the antenna started to blink. But flashing of the hood pin, programming the remote and programming the tach didn't do anything. I don't get any feedback from the vehicle of any sort (i.e. parking lights blinking). The vehicle still starts fine with the key, but the module isn't responding to anything.
Here's what I ended up doing:
On the 6-PIN harness, I connected everything except the 5th relay.
On the 5-PIN harness, everything is connected.
On the 12-PIN accessories harness, I only connected the negative (-) parking lights. I left everything not connected, so of course I don't have keyless.
I wanted to make the remote start work first, but then this. If I only want to have the remote start working, is it okay to leave the non-essentials to this function not connected? What would be the essentials?
I hope someone can help me out here... if it's not something I can figure out, then I'd have to go to the pro's to diagnose the problem. I hope they don't charge me as much as I've done most of the difficult part (e.g. laying out the wires).
Thanks in advance!