|
Re: Crank Sensor replacement night mare
Good morning,
I replaced the crank sensor on both our '97 as well as my '91. The '97 had no adjustment of the position of the pickup as I recall. Therefore there was nothing to align after fastening the sensor in place. Could some of the fins on the balancer be bent so that they touch the pickup? Maybe you can test the clearence of the fins to the pickup before completing the job!?? And I did have to use a puller on both the '97 and '91. Earlier models could removed by hand, I'm told.
As to the starting problem, if he new pickup is OK and there is no connector/wire problem associated with it, then maybe there is another source of not starting.
Regards,
Jack C.
Last edited by jcc3inc; 10-26-2009 at 09:44 AM.
Reason: another thought
|