Quote:
Originally Posted by lotus123
Mine shipped on the 2nd, so no problems there.
|
Just been delivered.
Some interesting items from AdlersNest here (armour detailing section!).
These rivet heads are size S (.6mm) and SS (.4mm) - the cut off rods look as if they could also be useful. I usually make rivets with my punch set, but it only gets down to 1mm. At 1/24 scale that's about 1 inch (or 2.5mm), which is still too large for some detail areas.
These bolt heads are M(1 mm) and SS (.6mm) Cut them flush for a bolt, or leave a bit of the rod on for a protruding bolt/nut.
