[david-b]

Update from yesterday...
Got pretty much everything except the crank pulley and sprocket from the old block. That thing is ready to get pulled. I'm think I may lower the car, and then drop the motor out through the bottom.

-All fuel lines in the bay are now SS with fittings
-SFMU installed
-Getting new alternator before it goes in
-Repainting all coolant lines
-Grinded down thermo housing to fit manifold

I just have to retap an exhaust hole (stud broke) and the manifold will be on along with the turbo.

Should start cutting out the strut tower sometime this week and get that going.

And need to finish up wiring megasquirt soon.

Not sure on when the new one is going in yet. I'm thinking 10/17 is looking good if not sooner