|
Re: LED turn signal prob's AFTER load EQ install
You might have it wired incorrectly. The resistor should be connected between the turn signal and ground wires.
I'm not familiar with the resistor part numbers but I'll guess that the "625" means it is a 6-Ohm, 25 Watt resistor. Doing the math for a 6 Ohm load @ 12 V, it translates to a 24 Watt draw through the resistor...pretty high. If you have more than one bulb that are flashing, then you may need a lower Ohm resistor. Refer to this nice little diagram:
http://www.plasmaled.com/tail_light_led_bulb_fix.htm
__________________
Current Garage:
2009 Honda CR-V EX
2006 Mazda 3i
2004 Chevrolet Silverado 2500HD
2003 GMC Envoy XL
2000 Honda ST1100
2000 Pontiac Sunfire
Vehicle History:
2003 Pontiac Vibe AWD - 1999 Acura Integra GS - 2004 4.7L Dakota Quad Cab 4x4 - 1996 GMC Jimmy 4wd - 1995 Chevrolet C2500 - 1992 Toyota Camry LE 2.2L - 1992 Chevrolet S10 Ext. Cab 4.3L - 1995 Honda ST1100 - 1980 Yamaha XS400 - 1980 Mercury Bobcat.
|