Quote:
Originally Posted by UKPonchoMan
I have recently used CF on my R34 Skyline and had horrendous problems - I started by trying to use decal setting solution, and when I realised this would not get around the compound curves, I used a hair dryer. This sucked the decal down perfectly, but where it overlapped, I could then not get it off the other panels, and I also had loads of micro blisters where the air was heated up and bubbled...
Can anyone recommend a good "how-to"? Or better yet, post one?
Many thanks,
Chris
|
Sharp #11 blade. Need a BUNCH of them. I buy them by the 100 pack and go through them in a month or two.
Use Micro Sol (the red stuff) to rehydrate them and cut with a sharp #11 blade where they overlap to reduce that effect.
Also patience is critical. I've learned that the hard way.
Hope this helps...
Daniel