Thread: Make a full exhaust for 420a Turbo
View Single Post
  #13  
Old 08-09-2009, 07:52 PM
boostjunkie333's Avatar
boostjunkie333 boostjunkie333 is offline
AF Enthusiast
  
Join Date: Jul 2008
Posts: 677
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via AIM to boostjunkie333
Re: Make a full exhaust for 420a Turbo
the angled muffler looks pretty fricken sweet

question...been meaning to ask...when you say welder...do mean the electric stick welder that you can buy like anywhere...

i need one, was wondering what you used, bc thats a pretty clean job you did there...and if you can do that with a regular portable welder, then i might just invest in one myself...

__________________
Hahn stage IV S16G-Portfueler w/400cc inj-1:1 Aeromotive FPR-Split sec fuel controller-Walbro 255lph FP-240cc inj-Hahn fuel mapper-JE pistons(8.1:1)-Total Seal rings-Eagle rods-ARP studs-AEM filter-C&R radiator-Hahn 3''downpipe & cat-Thermal Eng. 3''catback-LUK clutch & flywheel-Eibach springs-Eibach offset bushings-KYB GR2 struts-Strut bars-Lower rear tie bar-GReddy boost controller-Apexi T timer-Powerslot rotors-Gloshift gauges
Reply With Quote