OK so the evaporator had to be replaced, and I decided to tackle it myself. It actually wasn't as difficult as I was preparing myself for, but I have run into a problem. I cannot get the liquid line back on the evaporator. I replaced the o-rings, and the gas line went right on without issues. But the liquid line will not. I looked into the line side where the spring lock is, and there is a third o-ring by the spring. Is that supposed to be there? I was sure I took both old o-rings off, but I may have missed it.
If so, does anyone have any tips to reinstall these quick disconnects? I have played with this for hours now, and now the flare on the evaporator side is strating to flatten out at the bottom. Can I re-flare this with a flare tool??