Quote:
Originally Posted by toddman67
Well I certainly hope it all works out for you. You have had quite a challange with this engine. Pretty soon you will have a zipper on this thing! Good luck.
Todd
|
Thganks again TODD apreciate your comment, well today I removed the pin from the old piston, what a job, I used a big table vice but before I had to cut the old piston beside the pin so I had only the pin and the rod in hand, then i cut off the pin about 3/4 inches each side on the rod and put a big socket over one side and a smaller the other side same size of the pin. I put everything in the vice and started slowly and it came offf after 10 minutes of hard working without damaging the rod, I'M proud of me, this afternoon I will go to a shop to put the new piston pin on the old rod, they have to heat it I dont want to do this its a professionnal job I think, well thjink going good today.