|
Re: 1993 Town and Country wont start cam sensor replaced
Yahoo got it going again with the help of Wells Mfg. Co tech support. If anyone gets this mess here is what happened. I had dual problems the car died with all the symptoms of a camshaft sensor failing. I went to replace the camshaft sensor the replacement was defective because it only had a .015 air gap that should have been .029-.030. +/- .005 and the engine is dead as a door nail. Second problem is the camshaft sensor plug is very poorly designed for a major system. Any difference in the plug pin diameter will cause break of contact from side to side movement. Im considering clipping and soldering this plug to eliminate the connector contact risk.
__________________
"We must all hang together,or assuredly we shall all hang separately." ~~ Benjamin Franklin ~~
Last edited by sixseas; 06-27-2009 at 07:22 PM.
Reason: spelling errors
|