Quote:
Originally Posted by 25moose
On top of the ignition switch there are three thin wires with black friction tape covering. The wires are black, yellow, and white. Cut the yellow wire in two. Strip the insulation from the middle of the black wire but do not cut the wire. Place the red clip from a multi-tester on the yellow lead going to the ignition switch. Place the black clip on the bare section of the black lead. Try to start the car and read the resistance (mine is 557 ohms). Go to Radio Shack and get as close as you can get. I placed a 220 and 330 in series. Solder the resistor(s) between the bare section of black wire and the yellow lead that does not go to the ignition switch. Tape everything up and you should be good to go.
This is on a 2000 Malibu. I can't be sure that all are the same colors and set-up.
|
thank you very much will try it and let you know how i came out!
