[mdharmon]

Bad solder joints on the selector switch module. To remove the switch you need to remove the trim. Put the emergency brake on. Tilt steering down. Put the drive selector as far down as it can go. You'll need the key in. Now pull the trim off. It snaps out easily.

The selector module will require a flat tip screw driver to remove it from the dash. Pull the two connectors off the back and make sure to gently release the retainer clips that keep them on the there or they will break off.

To open the selector module use tiny flat tip screw drivers. There are three retainer clips on each long side of the module. Get two on one side and then start on the other. You'll see what I mean when you get started. Don't worry about spring flying or parts.

Once apart look for the two rows of solder joints. To make this work right remove the older solder before putting on new solder. Reflowing the old solder will work but will require rework in the future.

Good luck this is a good fix, you can do it!