Quote:
Originally Posted by keebler197
The motor is a V6 with the EDI ignition. It has the old style distrubitor with a vertical cap. and the fuel pump does prime for 3 sec after i turn the key on.
well here is what i have tested:
Dist. cap: put new one in
ignition module: good
igniton coil: replaced old and new one tests good
primary feed for igniton coil: good puts out 12v
ignition coil wire: tests good. with key on and pulged into the coil it puts out 12v
also stuck spark plug directly into it, grounded plug, and cranked the motor over trying to get a spark but noting
I wasn't sure about the sticking the spark plug in the wire but it seems like it should show a spark. So just incase i reattached everything and pulled out the #1 plug/wire and still didn't get anything
I also removed the dist. cap and cranked the motor to see if it was turning and it did.
Thanks for you response, any suggestions would help. I don't know what else to check.
|
On checking for spark best to use a spark jumping tester.
Apark plug does not make a good spark tester.
If ign coil and module is good next step is the dist pickup coil and wiring.