[Jag1980]

I have a 1998 Hyundai Elantra 1.8L with Automatic Transmission

I’m Using Code Reader Mac Tools ET50 (Launch CscannerIV)

Freeze Frame with no MIL Drove car then MIL come on with this code
P1600
Calculated Load 8.62%
S.T Fuel Trim B1 -82.81%
L.T Fuel Trim B1 -82.81%

Engine running with no MIL
Po713

Engine Codes Key on with MIL
P0310
Cylinder 10 Misfire Detected

P1700

P0710 (pd)
Transmission Fluid Temperature Sensor Circuit

P1B00 (pd)

My car is all stock. Been driving fine for months with no problems

My car died driving down the road with engine light on, tried 10 times to start the car but it failed to start.
15 Min's later the car started and no engine light, I was able to drive 5 miles and then it died again with engine light on, failed to start..
I let the car sit 15 Min's and then the car started and I was able to drive it the rest of the way home with the engine light on (about 5 miles)

I erased the codes
Car starts and I drove 50 feet and car died with engine light come back on, car started right up and drove it back wards 50 feet back to my driveway.
I checked the codes again and I am pulling all the codes that are mentioned above.

What could this be?