[wtijr]

Saturday I removed the cowl. The cabin air filter was disgusting. It was wet, and full of dirt. Fortunately it was dislodged so the blower motor was not trying to pull air through it. I replaced the filter and the bit of molding that redirects the water away from the filter opening. I used duct tape on the underside of the molding so it won't slip off again. There was a piece that I couldn't figure where it fit so I left it off. (it was the same width as the filter?) I'll check after the next rain to make sure water is not getting in.
The blower motor resistor is the next step. If anybody has a diagram/picture of its location, I would certainly appreciate seeing it.

Thanks