[Crvett69]

what you want to do to pull the axles is first, drain the transmission.take the nut off the axle. then jack up the car and remove the wheels. where the bottom control arm connects to the wheel hub you will se a 14mm bolt and nut . remove the bolt, then pull down or pry down on the control arm until the ball joint comes out of the hub. then using a pry bar between the axle inner cv joint and the transmission, pop it out of the tranny. once its out of the transmission you can pull outward on the bottom of the hub and axle should slide out. if it doesn't want to come out of the hub give it a few light taps, it should just slide out